Design carved in the wrong place

If your design carves in the wrong place, or part of the design is offset from another part or layer, here are a few things to check:
  1. Make sure your belts are tight.
  2. Make sure your v-wheels are not too tight and that the gantry slides freely when the power is turned off. If the eccentric nuts are tightened too much, it can cause the axes to bind.
  3. Make sure your axes are running in the correct direction with the correct settings, you can do this by going through the Easel Setup
  4. Make sure the current on your motors is high enough. You can adjust the current by turning the potentiometers on the gShield clockwise. 

Did you find this article helpful?